Temperature and Humidity Transmitter with Display – HTX-3000
HTX-3000 – Temperature and Humidity Transmitter with Display, 4-20mA/RS-485 Modbus/Ethernet Interface.
Technical Specifications :
Parameter | Description |
---|---|
Sensor | Hygroclip-XD or HTS-220 (common sensor for both T and RH) |
Temperature Range | -40.0 to 60.0oC (Using Hygroclip XD Sensor) |
0.0 to 60.0 oC (Using HTS-220 sensor) | |
Temperature Accuracy | Better than +/- 0.3 ?C |
%RH Range | 0.0 to 100.0 %RH (Using Hygroclip XD Sensor) |
10.0 to 100.0%RH (Using HTS-220 sensor) | |
RH Accuracy | Better than +/-1 %RH @ 25.0 ?C (using Hygroclip-XD sensor) |
Better than +/-3 %RH @ 25.0 ?C (using HTS-220 sensor) | |
Display for T and %RH | 4 digit each 0.3 Red / Green seven segment LED display |
Power Requirement (*) | 24VDC @ 150mA (+/-10%) . |
Output 1 for Temperature | 4-20mA proportional to selected Temp. range ( 12 bit resolution) |
Output 2 for %RH | 4-20mA proportional to 0 to 100.0 %RH (12 bit resolution) |
Load Resistance | RLmax. = 400 Ohms @ 24VDC. |
Serial Output (Optional) | Isolated 2 wire RS485 MODBUS RTU Slave protocol |
Ethernet Port (Optional) | Ethernet port on RJ-45 jack with TCP/IP protocol. |
Key board | Membrane key board is provided for programming the MODBUS address and for Range Calibration. |
Enclosure (Size) | ABS plastic (120 x 80 x 55) mm. |
Sensor Hygroclip XD | 14 x 140 mm with screw-on type plug and socket |
14 x 170 mm + 2meter long cable | |
Sensor HTS-220 | 60 x 35 x 15 mm + 2 meter long cable |
24VDC Adapter (Optional) | 24VDC adapter working on 90-250VAC can be supplied along with HTX-3000. |
Mounting / Cable Entry | Wall mounting using suitable clamps. Cable entry glands either at the left side or right side or at the rear side as per the requirement. |